Configure Snmpv3 Add Target-Params - Extreme Networks ExtremeWare Command Reference Manual

Commands for Managing the Switch

configure snmpv3 add target-params

configure snmpv3 add target-params [hex <hex value> | <param name>] user
[hex <hex value> | <user name>] mp-model [snmpv1 | snmpv2c | snmpv3]
sec-model [snmpv1 | snmpv2c | usm] {sec-level [noauth | authnopriv | priv]}
{volatile}
Description
Add and configure SNMPv3 target parameters.
Syntax Description
hex
param name
user name
mp-model
sec-model
snmpv1
snmpv2
usm
sec-level
noauth
authnopriv
authpriv
volatile
Default
The default values are:
• sec-level—noauth
• non-volatile storage
Usage Guidelines
Use this command to create an entry in the SNMPv3 snmpTargetParamsTable. This table specifies the
message processing model, security level, security model, and the storage parameters for messages to
any target addresses associated with a particular parameter name.
To associate a target address with a parameter name, see the command "configure snmpv3 add
target-addr" on page 154.
Example
The following command specifies a target parameters entry named P1, a user name of guest, message
processing and security model of SNMPv2c, and a security level of no authentication:
156
Specifies that the value to follow is to be supplied as a colon separated string
of hex octets.
Specifies the parameter name associated with the target.
Specifies a user.
Specifies a message processing model; choose from SNMPv1, SNMPv2, or
SNMPv3.
Specifies the security model to use.
Specifies the SNMPv1 security model.
Specifies the SNMPv2c security model.
Specifies the SNMPv3 User-based Security Model (USM).
Specifies the security level for the group.
Specifies no authentication (and implies no privacy) for the security level.
Specifies authentication and no privacy for the security level.
Specifies authentication and privacy for the security level.
Specifies volatile storage.
ExtremeWare 7.5 Command Reference Guide