Configure Snmp Delete Trapreceiver - Extreme Networks ExtremeWare Command Reference Manual

Hide thumbs Also See for ExtremeWare:

Table of Contents

configure snmp delete trapreceiver

configure snmp delete trapreceiver [ip address> | {all}]

Deletes a specified trap receiver or all authorized trap receivers.

Syntax Description

The default port number is 162.

Usage Guidelines

Use this command to delete a trap receiver of the specified IP address, or all authorized trap receivers.

Beginning in ExtremeWare 7.1.0, this command deletes only the first SNMPv1/v2c trap receiver whose

IP address and port number match the specified value.

If a trap receiver has been added multiple times with different community strings, the

option specifies that only the trap receiver entry with the specified community string should be

The following command deletes the trap receiver 10.101.0.100 from the trap receiver list:

configure snmp delete trapreceiver 10.101.0.100

The following command deletes entries in the trap receiver list for 10.101.0.100, port 9990:

configure snmp delete trapreceiver 10.101.0.100 port 9990

Any entries for this IP address with a different community string will not be affected.

This command was first available in ExtremeWare 2.0.

This command was modified in ExtremeWare 6.2.1 to support the

This command was modified in ExtremeWare 7.1.0 for SNMPv3 compatibility.

This command was added to the Summit "e" series of switches in 7.1e.

This command was modified in ExtremeWare 7.2e. for SNMPv3 compatibility.

ExtremeWare 7.5 Command Reference Guide

Specifies an SNMP trap receiver IP address.

Specifies all SNMP trap receiver IP addresses.

configure snmp delete trapreceiver

Extremeware 7.5