Extreme Networks ExtremeWare Command Reference Manual page 130

Commands for Managing the Switch
Default
Trap receivers are in enhanced mode by default, and the version is SNMPv2c by default.
Usage Guidelines
The IP address can be unicast, multicast, or broadcast.
An authorized trap receiver can be one or more network management stations on your network.
Authorized trap receivers must be configured on the switch for the trap receiver to receive
switch-generated traps. The switch sends SNMP traps to all trap receivers configured to receive the
specific trap group. If no trap groups are specified, all traps will be sent to the receiver. Entries in this
list can be created, modified, and deleted using the RMON2 trapDestTable MIB variable, as described in
RFC 2021.
Table 7 lists the currently defined SNMP trap groups. From time to time, new trap groups may be
added to this command.
Table 7: SNMP Trap Groups
Trap Group Notifications
stp-traps newRoot
topologyChange
1
bgp-traps bgpEstablished
bgpBackwardTransition
extremeBgpPrefixReachedThreshold
extremeBgpPrefixMaxExceeded
ospf-traps ospfIfStateChange
ospfVirtIfStateChange
ospfNbrStateChange
ospfVirtNbrStateChange
ospfIfConfigError
ospfVirtIfConfigError
ospfIfAuthFailure
ospfVirtIfAuthFailure
ospfIfRxBadPacket
ospfVirtIfRxBadPacket
ospfTxRetransmit
ospfVirtIfTxRetransmit
ospfOriginateLsa
ospfMaxAgeLsa
ospfLsdbOverflow
ospfLsdbApproachingOverflow
ping-traceroute-traps pingTestFailed
pingTestCompleted
tracerouteTestFailed
tracerouteTestCompleted
vrrp-traps vrrpTrapNewMaster
vrrpTrapAuthFailure
130
MIB Subtree
dot1dBridge, 1.3.6.1.2.1.17
bgpTraps, 1.3.6.1.2.1.15.7
extremeBgpTrapsPrefix, 1.3.6.1.4.1.1916.4.2.0
ospfTraps, 1.3.6.1.2.1.14.16.2
pingNotifications, 1.3.6.1.2.1.80.0
traceRouteNotifications, 1.3.6.1.2.1.81.0
vrrpNotifications, 1.3.6.1.2.1.68.0
ExtremeWare 7.5 Command Reference Guide