Extreme Networks ExtremeWare Command Reference Manual page 118

Commands for Accessing the Switch
Image Booted: Primary
Primary EW Ver: 7.0.0b61 [unknown-ssh]
Secondary EW Ver: 7.1.0b34 [non-ssh]
Module Image Selected
------ --------------
SMM Secondary
Slot 2 (WM4T1) Secondary
Config Selected: Primary
Config Booted: Primary
Primary Config: Created by EW Version:
7.1.0 Build 34
7928 bytes saved on Wed Jun 4 11:54:03 2003
Secondary Config: Created by EW Version:
6.2.2 Build 56 [38]
2900 bytes saved on Thu Jan 30 04:21:10 2003
The same example run on an "e" series switch would have the following output:
* Summit400-48t:2 # show switch
SysName: Summit400-48t
SysLocation:
SysContact: support@extremenetworks.com, +1 888 257 3000
System MAC: 00:04:96:18:40:AF
License: Advanced Edge
System Mode: 802.1Q EtherType is 8100 (Hex).
Recovery Mode: None
System Watchdog: Enabled
Reboot Loop Prot: Disabled
Current Time: Mon Jun 14 16:26:10 2055
Timezone: [Auto DST Enabled] GMT Offset: 0 minutes, name is GMT.
DST of 60 minutes is currently in effect, name is not set.
DST begins every first Sunday April at 2:00
DST ends every last Sunday October at 2:00
Boot Time: Mon Jun 14 16:19:20 2055
Config Modified: Thu Jan 1 00:00:00 1970
Next Reboot: None scheduled
Timed Upload: None scheduled
Timed Download: None scheduled
Temperature: Normal.
Power supply: Internal power supply OK, External power supply not present.
Primary EW Ver: 7.2e.0b28 beta.s400-r28 [non-ssh]
Secondary EW Ver: 7.2e.0b27 beta.s400-r27 [non-ssh]
Image Selected: Primary
Image Booted: Primary
Config Selected: Secondary
Config Booted: Secondary
Primary Config: Created by EW Version:
118
Image Booted
------------
Secondary
Secondary
[38]
All fans are operational.
ExtremeWare 7.5 Command Reference Guide