Enable Alt-Queue-Management - Extreme Networks ExtremeWare Command Reference Manual

Commands for Managing the Switch

enable alt-queue-management

enable alt-queue-management
Description
Enables the alternate queue management.
Syntax Description
This command has no arguments or variables.
Default
Disabled.
Usage Guidelines
Use this command to configure the alternative queue management feature for the next boot.
Configuring the feature does not affect the queue management current boot.
Use the command to display the alternative queue management feature status, as shown
show switch
in the following example:
MSM64:3 # show switch
SysName: MSM64
SysLocation:
SysContact: support@extremenetworks.com, +1 888 257 3000
System MAC: 00:01:30:12:2A:D0
License: Full L3
System Mode: 802.1Q EtherType is 8100 (Hex).
Diag Mode: Fast Post
RED Probability: 0
DLCS: Disabled
Backplane Ls: port-based
SysHealth Check: Enabled.
Recovery Mode: None
Transceiver Diag: Enabled.
Fdb-Scan Diag: Enabled.
MSM Failover: take-links-down
System Watchdog: Enabled
Reboot Loop Prot: Disabled
Alter Queue Mgmt: Disabled
Bus-stats: Disabled
Current Time: Wed Oct 29 18:58:17 2003
Timezone: [Auto DST Enabled] GMT Offset: 0 minutes, name is GMT.
DST of 60 minutes is currently not in effect, name is not set.
DST begins every first Sunday April at 2:00
DST ends every last Sunday October at 2:00
Press <SPACE> to continue or <Q> to quit:
194
Marked Probability: 0
Alarm Level = Log
Failure action:
Failure action:
Next Boot: Disabled
log only
sys-health-check
ExtremeWare 7.5 Command Reference Guide