Auto-Summary; Commands In This Chapter; Routing Information Protocol Commands - Dell Networking 7048 Reference Manual

Routing Information Protocol
Commands
The Routing Information Protocol (RIP) has been a long-standing protocol
used by routers for exchanging route information. RIP is a distance vector
protocol whereby each route is characterized by the number of gateways, or
hops, a packet must traverse to reach its intended destination. Categorized as
an interior gateway protocol, RIP operates within the scope of an autonomous
system. RIP is a simple protocol. Its usefulness is limited to moderately sized
networks whose physical interconnections are of similar type and speed.
PowerConnect routing supports RIPv2 as specified in RFC 2453.

Commands in this Chapter

This chapter explains the following commands:

auto-summary

default-information
originate (Router RIP
Configuration)
default-metric
distance rip
distribute-list out
enable
auto-summary
Use the auto-summary command in Router RIP Configuration mode to
enable the RIP auto-summarization mode. Use the no form of the command
to disable auto-summarization mode.
hostroutesaccept
ip rip
ip rip authentication
ip rip receive version
ip rip send version
redistribute

Routing Information Protocol Commands

56
router rip
show ip rip
show ip rip interface
show ip rip interface brief
split-horizon
–
1307