Table of Contents
Advertisement
Hot-Plug Power Supply
Observe the following conditions for AC power supplies:
To remove the component:
1. Disconnect the power cord from the power supply.
2. Remove the blower ("Blower" on page 16).
−
The blower begins operating immediately.
−
The power supply/blower assembly LED is green.
CAUTION: Removing a power supply significantly changes
the airflow within the chassis. The storage system will shut down to
prevent overheating unless the power supply is replaced within
5 minutes.
CAUTION: Handle the blower carefully to avoid damaging the
housing:
•
Do not press on the center section of the blower because this action
can damage the blades. Press only on the outer edge of the blower.
•
Do not rest the power supply on the blower because the weight of
the power supply can damage the blower housing.
Removal and Replacement Procedures
17
Advertisement
Table of Contents
