Lexmark W820 - Optra B/W Laser Printer Service Manual page 59

Pre-Reg
Print cycle
Print surface
PS
PWB
R
R
Reg or Regi
R/H
ROM
RTN
S
Sensor
SG
Signal name
SNR
SOL
SOS
STA
STS
SW
T
Temp
Test Print
Test Print Mode
Toggle
Toner
Transfer
V-
V
VAC
VDC
W-
Warm-up
4025-Finisher
Pre-Registration
The printer creating and delivering one finished print
The side of a sheet of paper that receives the printed image
Power Supply
Printed Wiring Board (sometimes referred to as PCB or
Printed Circuit Board)
Right
Registration
Right Hand
Read Only Memory
Return
A device used to monitor a function or operation, such as
paper travel along the paper path
Signal Ground
A name assigned to a wire, indicating the purpose of the wire
and/or the voltage carried by that wire
Sensor
Solenoid
Start Of Scan
Status
Soft Touch Sensor
Switch
Temperature
A grid pattern print that is generated by the MCU
The mode of operation that lets you generate a test print
To switch between two states, such as on and off or up and
down
The dry ink that is used to create the visible image. Toner is
stored in the EP Cartridge
Moving the toner image from the surface of the drum to the
surface of a sheet of paper
Volts
Volts - Alternating Current
Volts - Direct Current
The time it takes the printer to go from main power ON to
Ready to Print
1-47
Introduction