Solenoid Assembly-Gate In Removal - Lexmark W820 - Optra B/W Laser Printer Service Manual

Solenoid Assembly-Gate In Removal

Removal
1.
Remove the Rear Cover.
2.
Unplug the connector (P/J 256M) of the Solenoid Assembly.
3.
Unclamp the harness of the Solenoid Assembly at five places on the Bracket
Assembly.
4.
Pull the Roller off the shaft of the Bracket Assembly.
5.
Remove two screws that secure the Cover Assembly Solenoid, and remove the
Cover Assembly Solenoid together with the Solenoid Assembly-Gate In.
6.
Pull the Bracket Assembly Damper off the Cover Assembly Solenoid with your
fingers.
7.
Remove the screw that secures Solenoid Assembly to the Cover Assembly
Solenoid, and remove the Solenoid Assembly-Gate In.
8.
Pull off the Link Assembly Damper together with the plunger of the Solenoid
Assembly.
9.
Sliding the Link Assembly Damper, remove it from the plunger of the Solenoid
Assembly.
4025-Finisher
Removal and Replacement Procedures
4-11