Roll Transport Removal - Lexmark W820 - Optra B/W Laser Printer Service Manual

Roll Transport Removal

Removal
1.
2.
3.
4.
5.
6.
7.
8.
9.
WARNING: In the following steps, take care not to allow the harness to get stuck to the
roller.
10.
11.
4-44
Service Manual
Remove the Cover-Jogging.
Remove the Cover-Top, Front and Cover-Top, Rear.
Remove the Cover-Open, Front, Cover-Front and Kit Stud Cover.
Remove the Cover-Rear.
Remove the Cover Top Left.
Remove the Top Center Cover Assembly.
Remove the Sensor, Input Path.
Remove the Kit Drive Assembly.
Remove the Bearing that secures the shaft on the front side of the Roll Transport.
Lift up the Roll Transport a little, and move it toward the rear so that the leading end
of the shaft on the front side enters into the inside of the Finisher frame.
Lift up the shaft on the front side of the Roll Transport, and pull it off.
4025-Finisher