Kit Gear Front Removal - Lexmark W820 - Optra B/W Laser Printer Service Manual

Kit Gear Front Removal

Removal
1.
Remove the Cover-Jogging.
2.
Remove the Cover-Top, Front.
3.
Remove the Cover-Open, Front, Cover-Front and Kit Stud Cover.
4.
Remove the Motor Assembly-MP4.
5.
Unclamp the harness of the Clamp.
6.
Remove the E-ring that secures the Pulley to the shaft of the Paddle Shaft Assembly.
7.
Remove two screws that secure to the Finisher from the Bracket, and pull off the
Bracket together with the Bearing, Clamp and Kit Gear Front toward the front.
8.
Remove the E-ring that secures the Pulley Gear to the Bracket, and remove the
Pulley Gear.
Replacement
1.
Insert the Pulley Gear into the shaft of the Bracket, and secure it with an E-ring.
2.
With the Pulley and Pulley Gear meshed with the Belt, insert the Pulley into the shaft
of the Paddle Shaft Assembly, and align the Bracket with the mounting position in the
Finisher, and then secure it with two screws.
3.
Secure the Pulley to the shaft of the Paddle Shaft Assembly with an E-ring.
4.
Clamp the harness with the Clamp.
5.
Mount the Motor Assembly-MP4.
6.
Mount the Cover-Open, Front, Cover-Front and Kit Stud Cover.
7.
Mount the Cover-Top, Front.
8.
Mount the Cover-Jogging.
4025-Finisher
Removal and Replacement Procedures
4-83