Lexmark W820 - Optra B/W Laser Printer Service Manual page 194

Removal
1.
2.
3.
Note: In the following steps, removing the Lever, Spring and Sector Gear allows the Pin
inserted into the hole in the Shaft to be unsecured. Take care not to drop or lose it.
4.
5.
Replacement
1.
2.
3.
4.
5.
6.
7.
8.
4-86
Service Manual
Remove the Cover-Jogging.
Remove the Cover-Top, Front.
Remove the Compiler Roll and Roll Shaft.
Remove the E-ring that secures the Lever, Spring and Sector Gear to the Shaft, and
pull off the Lever, Spring and Sector Gear.
Remove the Pin from the Shaft.
Insert the Pin into the hole in the Shaft, and then the Lever into the Shaft.
Insert the longer hook of the Spring into the Shaft, and engage the long hook of the
Spring with the upper of the Lever.
Insert the Sector Gear in the midway of the Shaft, and engage the shorter hook of
the Spring with the lower of the Shaft. (Figure 2)
Turn the Sector Gear counterclockwise to hook it to the lower of the Lever. (Figure 2)
Secure the Lever, Spring and Sector Gear to the Shaft with an E-ring.
Mount the Compiler Roll and Roll Shaft.
Mount the Cover-Top, Front.
Mount the Cover-Jogging.
4025-Finisher