Kit Bracket Assembly And Screw Removal - Lexmark W820 - Optra B/W Laser Printer Service Manual

Kit Bracket Assembly and Screw Removal

Removal
1.
Place several-ply cardboards or newspapers on the floor, and carefully tumble the
Finisher from the left side.
2.
Remove two Thumbscrews on the front side.
3.
Sliding the Bracket Assembly on the front side toward the inside, remove the Bracket
Assembly.
4.
For the Bracket Assembly and Thumbscrews on the rear side, perform the above
steps in the same manner.
Replacement
Note: Align the holes on both front and rear sides of the Frame Post with the holes on
both front and rear sides of the Finisher.
1.
Align two pins on the front side of the Bracket Assembly with the holes in the
Finisher.
2.
Push in the Bracket Assembly on the front side up to the specified position, and
secure it with two Thumbscrews.
3.
For the Bracket Assembly and Thumbscrews on the rear side, perform the above
steps in the same manner.
4.
Erect the Finisher carefully.
4025-Finisher
Removal and Replacement Procedures
4-35