Sensor, Path Removal
Removal
1.
2.
3.
4.
5.
Replacement
1.
2.
3.
4.
4-58
Service Manual
Open the Top Center Cover Assembly.
Remove the second Kit Roll Pinch from the rear.
Unplug the connector (P/J 2) of the Harness Sensor from the Sensor, Path.
Pressing the leading end of the Sensor, Path downward with your finger, disengage
two hooks on the upper side by pushing with a small screwdriver.
Disengage two hooks on the lower side of the Sensor, Path by pushing with a small
screwdriver, and remove the Sensor, Path.
Align the Sensor, Path with the mounting position in the Finisher so that the
connector faces toward the rear, and hook it at four places.
Plug the connector (P/J 2) of the Harness Sensor to the Sensor, Path.
Mount the second Kit Roll Pinch from the rear.
Close the Top Center Cover Assembly.
4025-Finisher