Lexmark W820 - Optra B/W Laser Printer Service Manual page 153

Replacement
WARNING: In the following steps, take care not to allow the harness to get stuck to the
roller.
1.
Let the shaft on the rear side of the Roll Transport through under the harness of the
Finisher, and insert it into the bearing on the rear side.
2.
Insert the shaft on the front side of the Roll Transport into the bearing on the front
side of the Finisher, and secure it with the Bearing.
3.
Mount the Kit Drive Assembly.
4.
Mount the Sensor, Input Path.
5.
Mount the Top Center Cover Assembly.
6.
Mount the Cover Top Left.
7.
Mount the Cover-Rear.
8.
Mount the Cover-Open, Front, Cover-Front and Kit Stud Cover.
9.
Mount the Cover-Top, Front and Cover-Top, Rear.
10.
Mount the Cover-Jogging.
4025-Finisher
Removal and Replacement Procedures
4-45