Lexmark W820 - Optra B/W Laser Printer Service Manual page 211

Replacement
1.
Align the Motor Assembly-MP8 with the mounting position in the Damper, and
secure it with two screws.
2.
Insert the Gear into the shaft of the Motor Assembly-MP8, and secure it with an E-
ring.
3.
Align the Damper, together with the Gear and Motor Assembly-MP8, with the large
frame of the stapler, and secure them with two screws.
4.
Plug the connector (CN 8) of the Harness Motor to the Motor Assembly-MP8.
5.
Mount the Latch Assembly and Switch Docking.
6.
Align the Cover Upper Left Assembly, with the mounting position in the frame of the
Finisher, and secure them with six screws.
7.
Mount the Inner Cover.
8.
Mount the Cover-Open, Front, Cover-Front and Kit Stud Cover.
9.
Mount the Cover-Rear.
10.
Mount the Cover-Top, Front and Cover-Top, Rear.
11.
Mount the Cover-Jogging.
12.
Mount the Bottle Assembly-Dust.
13.
Mount the Cartridge.
4025-Finisher
Removal and Replacement Procedures
4-103