Lexmark W820 - Optra B/W Laser Printer Service Manual page 145

Replacement
1.
Insert the Frame Post in parallel to the Finisher, and align four holes in the Frame
Post with four holes in the Finisher.
2.
Aligning the hole in the Roll with the shaft holes for the wheels located on the rear
left side, insert the Pin Right from the rear side and secure it with an E-ring.
3.
Aligning the hole in the Roll with the shaft holes for the wheels located on the rear
right side, insert the Pin Right from the rear side and secure it with an E-ring.
4.
Aligning the hole in the Roll with the shaft holes for the wheels located on the front
right and left sides, insert the Pin Right from the rear side and secure it with an E-
ring.
5.
Mount the Caster Assembly.
6.
Mount the Cap-End.
7.
Mount the Kit Bracket Assembly and Screw.
8.
Erect the Finisher carefully.
4025-Finisher
Removal and Replacement Procedures
4-37