Motor Assembly-MP2 Removal
Removal
1.
Remove the Cover-Jogging.
2.
Remove the Cover-Top, Rear.
3.
Remove the Cover-Rear.
4.
Unclamp the harness of the Clamp.
5.
Unplug the connector (CN 2) of the Harness Motor from the Motor Assembly-MP2.
6.
Remove the screw that secures to the Motor Assembly-MP4 from the Motor
Assembly-MP2.
WARNING: In the following steps, the Bearing is not secured and easily removed. Take
care not to drop or damage it.
7.
Remove two screws that secure to the Finisher from the Motor Assembly-MP2, and
remove the Motor Assembly-MP2 together with the Bearing.
4025-Finisher
Removal and Replacement Procedures
4-77