Roll Assembly-Regi Removal - Lexmark W820 - Optra B/W Laser Printer Service Manual

Roll Assembly-REGI Removal

Removal
1.
Remove the Cover-Jogging.
2.
Remove the Cover-Top, Front and Cover-Top, Rear.
3.
Remove the Top Center Cover Assembly.
4.
Remove the Cover-Open, Front, Cover-Front and Kit Stud Cover.
5.
Remove the Knob, Regi Roller.
6.
Remove the Puncher.
7.
Remove the Guide Assembly-Dust.
8.
Remove the Bearing that secures the shaft on the front side of the Roll Assembly-
REGI.
9.
Slide the Roll Assembly-REGI toward the front (1), and lifting up the shaft on the rear
side pull it off in a diagonal upward direction. (2)
Replacement
1.
From the inside of the Finisher, insert the shaft on the front side of the Roll
Assembly-REGI into the mounting hole.
2.
From the inside of the Finisher, insert the shaft on the rear side of the Roll Assembly-
REGI into the mounting hole, and secure the shaft on the front side of the Roll
Assembly-REGI with the Bearing.
3.
Mount the Guide Assembly-Dust.
4.
Mount the Puncher.
5.
Mount the Knob, Regi Roller.
6.
Mount the Cover-Open, Front, Cover-Front and Kit Stud Cover.
7.
Mount the Top Center Cover Assembly.
8.
Mount the Cover-Top, Front and Cover-Top, Rear.
9.
Mount the Cover-Jogging.
4025-Finisher
Removal and Replacement Procedures
4-43