Replacement
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
4-112
Service Manual
Align the Cable-Flat with the mounting position in the large frame of the stapler, and
secure it with two screws.
Align the Cable-Flat with the mounting position in the small frame of the stapler, and
secure it with two screws.
Close the small plate together with the Stapler Holder. (Figure 3)
Engage the Belt with the gear to which a driving force is transmitted directly from the
Motor Assembly-MP8 on the large frame of the stapler.
Hook the Spring on the back of the stapler. (Figure 2)
Mount the Stapler Assembly.
Mount the Latch Assembly and Switch Docking.
Align the Cover Upper Left Assembly, with the mounting position in the frame of the
Finisher, and secure them with six screws. (Figure 1)
Mount the Inner Cover.
Mount the Stapler Assembly
Mount the Cover-Open, Front, Cover-Front and Kit Stud Cover.
Mount the Cover-Rear.
Mount the Cover-Top, Front and Cover-Top, Rear.
Mount the Cover-Jogging.
Mount the Bottle Assembly-Dust.
Mount the Cartridge.
4025-Finisher