Lexmark W820 - Optra B/W Laser Printer Service Manual page 241

Removal
1.
Remove the Cover-Jogging.
2.
Remove the Cover-Top, Rear.
3.
Remove the Cover-Rear.
4.
Unplug the connector (P/J 1A) of the Harness DC from the PWB Assembly-Main.
5.
Unplug the connector (P/J 2A) of the Harness DC from the PWB Assembly-Main.
6.
Unplug the connector (P/J 3A) of the Harness Middle Stapler from the PWB
Assembly-Main.
7.
Unplug the connector (P/J 4A) of the Harness Motor from the PWB Assembly-Main.
8.
Unplug the connector (P/J 6A) of the Harness Motor from the PWB Assembly-Main.
9.
Unplug the connector (P/J 7A) of the Harness DC from the PWB Assembly-Main.
10.
Unplug the connector (P/J 9A) of the Harness Middle Stapler from the PWB
Assembly-Main.
11.
Unplug the connector (P/J 10A) of the Harness Sensor from the PWB Assembly-
Main.
12.
Unplug the connector (P/J 11A) of the Harness H-Try from the PWB Assembly-Main.
13.
Unplug the connector (P/J 12A) of the Harness Sensor from the PWB Assembly-
Main.
14.
Unplug the connector (P/J 13A) of the Harness Middle 1 from the PWB Assembly-
Main.
15.
Unplug the connector (P/J 16A) of the Harness I/F from the PWB Assembly-Main.
16.
Unplug the connector (P/J 18A) of the Harness Face Up from the PWB Assembly-
Main.
17.
Remove four screws that secure to the Finisher from the PWB Assembly-Mainland
and remove the PWB Assembly-Main.
4025-Finisher
Removal and Replacement Procedures
4-133