Spring Tension 80, Sensor And Harness Earth Removal - Lexmark W820 - Optra B/W Laser Printer Service Manual

Spring Tension 80, Sensor and Harness Earth Removal

Removal
1.
Remove the Rear Cover.
2.
Unhook the tension spring 80 from the hole in the H-Tra frame.
3.
Remove two screws that secure the tension bracket assembly to the H-Tra, and
remove the tension bracket assembly together with tension spring 80.
4.
Unhook the tension spring 80 from the hole in the tension bracket assembly, and
remove the tension spring Tension 80.
5.
Unplug the connector (P/J 260) of the H-Tra harness assembly from the sensor.
6.
Unhook the sensor at three places, and remove the sensor.
7.
Remove two screws that secure the earth harness to the H-Tra, and remove the
earth harness.
4025-Finisher
0, Sensor and Harness Earth Removal
Removal and Replacement Procedures
4-3