Gear Kit Removal
Removal
1.
2.
3.
4.
5.
6.
7.
4-150
Service Manual
Remove the Cover-Top, Front and Cover-Top, Rear.
Disengage the hook (long hook) that secures the Tension Spring to the frame.
Remove two screws that secure to the Finisher from the Tension Bracket, and
remove the Tension Bracket together with the Tension Roll and Tension Spring.
Release the Belt from the Pulley Small, and remove the Belt.
Remove the E-ring that secures the Pulley Small to the shaft of the Upper Roll, and
remove the Pulley Small.
Remove the E-rings that secure the Pulley Large and Pulley Small to the shafts of
upper and lower Roll Transport, and remove the Pulley Large.
Remove the E-ring that secures the Pulley Drive to the shaft of the Stepping Motor,
and remove the Pulley Drive.
4025-Finisher