Holder Assembly Removal - Lexmark W820 - Optra B/W Laser Printer Service Manual

Holder Assembly Removal

Removal
1.
2.
3.
4.
Note: In the following steps, the procedure on the front is the same as on the rear. Apply
the same procedure to the rear.
5.
6.
7.
8.
9.
10.
4-116
Service Manual
Remove the Cover-Jogging.
Remove the Cover-Top, Front and Cover-Top, Rear.
Remove the Cover-Rear.
Remove the Cover-Open, Front, Cover-Front and Kit Stud Cover.
Remove two screws that secure the lower Holder to the Bracket Front.
Disengage the Spring from the upper and lower Holder using radio pliers, and
remove the Spring.
Remove two screws that secure the upper Holder to the Bracket.
Disengage the screw hole in the upper Holder from the hole in the Bracket Front, and
push the upper Holder inside to remove it.
Disengage the screw hole in the lower Holder from the hole in the Bracket Front, and
push the lower Holder inside to remove it.
Release the Belt from the upper and lower Pulley, and remove it.
4025-Finisher