Lexmark W820 - Optra B/W Laser Printer Service Manual page 135

Service manual
Hide thumbs Also See for W820 - Optra B/W Laser Printer:
Table of Contents

Advertisement

Replacement
1.
Aligning the shaft in the center of the Cover-Front with the bearing in the center of
the Cover-Open, Front, push them in to mount the Cover-Open, Front on the Cover-
Front.
2.
Insert the Stud Cover into the hole at the bottom surface of the Cover-Open, Front,
and secure the lower Cover-Open, Front.
3.
Insert the Stud Cover into the hole at the top surface of the Cover-Open, Front, and
secure the upper Cover-Open, Front.
4.
Align the Cover-Front with the mounting position in the Finisher so that two bosses
are engaged, and secure the Cover-Front together with the Stud Cover and Cover-
Open, Front using four screws.
5.
Secure the Cover-Open, Front to the Finisher with three screws.
6.
Mount the Cover-Jogging.
4025-Finisher
Removal and Replacement Procedures
4-27

Advertisement

Table of Contents
loading

This manual is also suitable for:

W820 finisher 4025-xxx

Table of Contents