Stapler II Assembly Removal
Removal
1.
Open the Cover-Open, Front.
2.
Unplug the connector (CN 10) of the Stapler harness assembly from the Stapler
Assembly.
3.
Turn the knob of the stapler counterclockwise to face the stapler toward the front.
4.
Remove two screws that secure to the Stapler Assembly from the Stapler Holder.
5.
Lifting up the front of the Stapler Assembly, and pull it off.
Replacement
1.
Holding the shaft on the front of the Stapler Assembly to the hook of the Stapler
Holder, align the hole on the front of the Stapler Assembly with the screw hole in the
Stapler Holder.
2.
Secure the Stapler Holder to the Stapler Assembly with two screws.
3.
Plug the connector (CN 10) of the Stapler harness assembly to the Stapler
Assembly.
4.
Close the Cover-Open, Front.
4025-Finisher
Removal and Replacement Procedures
4-97