Lexmark W820 - Optra B/W Laser Printer Service Manual page 235

Removal
1.
Remove the Cover-Jogging.
2.
Remove the Tray-Lower.
3.
Remove the Cover-Top, Front and Cover-Top, Rear.
4.
Remove the Cover-Rear.
5.
Remove the Cover-Open, Front, and Kit Stud Cover.
6.
On the Front of the Finisher, loosen the two screws that secure the Bracket Tray
Lower.
7.
On the Rear of the Finisher, loosen the two screws that secure the Bracket Tray
Lower, and Remove the Bracket Tray Lower.
8.
Remove seven screws that secure the lower Right Cover to the Bracket (PL20.14.3).
9.
Remove two screws that secure the Finisher from the Right Cover.
10.
Remove four screws that secure the Stack Arm Assembly from the Right Cover.
11.
Remove the screw that secure the No Paper Sensor from the Right Cover.
12.
Remove the Right Cover from the Finisher.
Replacement
1.
Align the Right Cover with the mounting position on the Finisher.
2.
Secure the Right Cover to the No Paper Sensor with a screw.
3.
Secure the Right Cover to the Stack Arm Assembly with four screws.
4.
Secure the Right Cover to the Finisher with two screws.
5.
Secure the Right Cover to the Finisher with seven screws.
6.
Align the Bracket Tray Lower, with the mounting position, and secure it with four
screws.
7.
Mount the Cover-Open, Front, Cover-Front and Kit Stud Cover.
8.
Mount the Cover-Rear.
9.
Mount the Cover-Top, Front and Cover-Top, Rear.
10.
Mount the Tray-Lower.
11.
Mount the Cover-Jogging.
4025-Finisher
Removal and Replacement Procedures
4-127