Latch Assembly And Switch Docking Removal - Lexmark W820 - Optra B/W Laser Printer Service Manual

Latch Assembly and Switch Docking Removal

Removal
1.
Remove the Cover-Jogging.
2.
Remove the Cover-Top, Front.
3.
Remove the Cover-Rear.
4.
Remove the Cover-Open, Front, Cover-Front and Kit Stud Cover.
5.
Remove two screws that secure to the Finisher from the Bracket Inlet, and shift the
Bracket Inlet together with the Inlet to the right direction.
6.
Remove four screws that secure to the Finisher from the Cover Lower Left.
7.
Remove four screws that secure to the Latch Assembly from the Cover Lower Left,
and remove the Cover Lower Left.
Note: In the following steps, do not detach the Latch Assembly far away because the
connector and harness are still connected.
8.
Remove three screws of the Cover Switch Docking that secure to the back of the
Latch Assembly, and remove the Cover Switch Docking.
9.
Unhook the two Clamps, and release the harness.
10.
Unplug the connector (S1-1) of the Harness Docking from the Switch Docking.
11.
Remove two screws of the Switch Docking that secure to the back of the Latch
Assembly, and remove the Switch Docking.
4025-Finisher
Removal and Replacement Procedures
4-29