Lexmark W820 - Optra B/W Laser Printer Service Manual page 225

Replacement
Note: In the following steps, the procedure on the front is the same as on the rear. Apply
the same procedure to the rear.
1.
Engage the Belt with the upper and lower Pulley.
2.
Engage the Belt with the lower Holder, and align the lower Holder, together with the
Belt, with the mounting position.
3.
Engage the Belt with the upper Holder so as not to slacken the Pulley, and align the
upper Holder, together with the Belt, with the mounting position.
4.
Secure the upper Holder to the Bracket Front with two screws.
5.
Engage the Spring with the upper and lower Holder using radio pliers.
6.
Secure the lower Holder to the Bracket Front with two screws.
7.
Mount the Cover-Open, Front, Cover-Front and Kit Stud Cover.
8.
Mount the Cover-Rear.
9.
Mount the Cover-Top, Front and Cover-Top, Rear.
10.
Mount the Cover-Jogging.
4025-Finisher
Removal and Replacement Procedures
4-117