Port Harness Assembly Removal - Lexmark W820 - Optra B/W Laser Printer Service Manual

Port Harness Assembly Removal

Removal
1.
Remove the Cover-Jogging.
2.
Remove the Cover-Top, Rear.
3.
Remove the Cover-Rear.
4.
Release two Clamp on the PWB Chassis to release the harness.
5.
Unplug the connector (P/J 11A) of the Harness H-Tra from the PWB Assembly-Main.
6.
Unplug the connector (P/J 16) of the Harness H-Tra from the PWB Assembly-Main.
7.
Unplug the connector (CN 17) of the Harness H-Tra from the Harness Motor.
8.
Remove two screws that secure to the Finisher from the Harness H-Tra, and remove
the Port harness assembly.
Replacement
1.
Align the with the mounting position in the Finisher, and secure it with two screws.
2.
Plug the connector (CN 17) of the Harness H-Tra to the Harness Motor.
3.
Plug the connector (P/J 16) of the Harness H-Tra to the PWB Assembly-Main.
4.
Plug the connector (P/J 11A) of the Harness H-Tra to the PWB Assembly-Main.
5.
Bundle the harness with two Clamp on the PWB Chassis.
6.
Mount the Cover-Rear.
7.
Mount the Cover-Top, Rear.
8.
Mount the Cover-Jogging.
4025-Finisher
Removal and Replacement Procedures
4-135