Bracket Assembly Removal - Lexmark W820 - Optra B/W Laser Printer Service Manual

Bracket Assembly Removal

Removal
1.
2.
3.
4.
5.
6.
7.
8.
Replacement
1.
2.
3.
4.
5.
6.
7.
8.
4-6
Service Manual
Remove the Rear Cover.
Unplug the connector (P/J 260) of the H-Tra harness assembly from the sensor.
Remove the Pulley 2, tension spring 80, sensor and earth harness.
Remove the Solenoid Assembly-gate in.
Remove the Transport Gear Kit.
Remove three screws that secure the bracket assembly together with three spring
plate to the H-Tra, and remove three spring plate.
Remove the screw that secures the bracket assembly, and remove the bracket
assembly together with the saddle clamp.
From the back of the bracket assembly, tighten each latch of the five saddle clamp
with pliers to remove them.
Push the five Saddle Clamps into five holes in the Bracket Assembly to mount them.
Align the Bracket Assembly with the mounting position in the H-Tra, and secure it
with a screw.
Align the Three Spring Plate with the mounting positions on the Bracket Assembly,
and secure them with a screw respectively.
Mount the Transport Gear Kit.
Mount the Solenoid Assembly-gate in.
Mount the Pulley 2, Spring Tension 80, and the Sensor And Harness Earth.
Plug the connector (P/J 260) of the H-Tra Harness Assembly to the sensor.
Mount the Rear Cover.
4025-Finisher