Sensor Tray Height Front Removal - Lexmark W820 - Optra B/W Laser Printer Service Manual

Sensor Tray Height Front Removal

Removal
1.
Remove the Cover-Jogging.
2.
Remove two screws that secure to the Finisher from the Sensor Tray Height Front,
and pull off the Sensor Tray Height Front a little.
3.
Unplug the connector (P/J 1C-L) of the Harness Sensor from the Sensor Tray Height
Front.
4.
For the rear, perform the above step in the same manner.
Replacement
1.
Plug the connector (P/J 1C-L) of the Harness Sensor to the Sensor Tray Height
Front.
2.
Align the Sensor Tray Height Front with the mounting position in the Finisher, and
secure it with two screws.
3.
For the rear, perform the above step in the same manner.
4.
Mount the Cover-Jogging.
4025-Finisher
Removal and Replacement Procedures
4-119