Replacement
1.
From the diagonal upper rear direction, mount the Motor Assembly-Swing so that the
shaft can enter.
2.
Plug the connector (CN 9) of the Stapler harness assembly to the Motor
Assembly-Swing.
3.
Mount the Stapler harness assembly.
4.
Mount the Stapler Assembly.
5.
Mount the Latch Assembly and Switch Docking.
6.
Align the Cover Upper Left Assembly, with the mounting position in the Finisher
frame, and secure them with six screws.
7.
Mount the Inner Cover.
8.
Mount the Stapler Assembly.
9.
Mount the Cover-Open, Front, Cover-Front and Kit Stud Cover.
10.
Mount the Cover-Rear.
11.
Mount the Cover-Top, Front and Cover-Top, Rear.
12.
Mount the Cover-Jogging.
13.
Mount the Bottle Assembly-Dust.
14.
Mount the Cartridge.
4025-Finisher
Removal and Replacement Procedures
4-105