Belt-Sync Removal - Lexmark W820 - Optra B/W Laser Printer Service Manual

Belt-Sync Removal

Removal
1.
Remove the Rear Cover.
2.
Unplug the connector (P/J 260) of the H-Tra harness assembly from the sensor.
3.
Remove the Pulley 2, tension spring 80, sensor and earth harness.
4.
Remove the Solenoid Assembly-gate in.
5.
Remove the Transport Gear Kit.
6.
Remove the Bracket Assembly.
7.
Remove the Belt-sync from the H-Tra.
Replacement
1.
Mount the Belt-sync while taking care of the routing to the gear and pulley on the
H-Tra.
2.
Mount the Bracket Assembly.
3.
Mount the Transport Gear Ki
4.
Mount the solenoid assembly-gate in.
5.
Mount the pulley 2, tension spring 80, sensor and earth harness.
6.
Plug the connector (P/J 260) of the H-Tra harness assembly to the sensor.
7.
Mount the Rear Cover.
4025-Finisher
t.
Removal and Replacement Procedures
4-5