Staple Stage Assembly, Stack Roll Shaft, No Paper Sensor Stapler Removal - Lexmark W820 - Optra B/W Laser Printer Service Manual

Staple Stage Assembly, Stack Roll Shaft, No Paper Sensor
Stapler Removal
Removal
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
WARNING: In the following steps, do not detach the Bracket far away because the
connector (P/J 13) of the No Paper Sensor Stapler is still connected.
16.
4-88
Service Manual
Remove the Cover-Jogging.
Remove the Cover-Top, Front and Cover-Top, Rear.
Remove the Cover-Open, Front, Cover-Front and Kit Stud Cover.
Remove the Cover-Rear.
Remove the Kit Motor Jogging.
Remove the Motor.
Remove the Motor Assembly-MP2.
Remove the Compiler Roll and Roll Shaft.
Remove the Cartridge.
Remove the Bottle Assembly-Dust.
Remove the Stapler Assembly.
Remove the Right Cover.
Remove the E-ring that secure the Bearing and Gear to the front of the Stack Roll
Shaft, and remove the Bearing and Gear.
Remove the E-ring that secures the Bearing to the rear of the Stack Roll Shaft, and
remove the Bearing.
Remove the Shoulder Screws on the front that secure the Staple Stage Assembly,
together with Spacer, to the Finisher, and remove the Spacers.
Remove the Shoulder Screws on the rear that secure the Staple Stage Assembly to
the Finisher.
4025-Finisher