Lexmark W820 - Optra B/W Laser Printer Service Manual page 120

Replacement
1.
2.
3.
4.
5.
6.
7.
8.
9.
4-12
Service Manual
Sliding the Link Assembly Damper so that the convex of the Solenoid Assembly is
engaged with the concave of the plunger of the Solenoid Assembly, mount the Link
Assembly Damper.
Insert the Spring Solenoid into the plunger of the Solenoid Assembly, and push the
Link Assembly Damper together with the Spring Solenoid and the plunger of the
Solenoid Assembly into the hole in the solenoid.
Align the Solenoid Assembly together with the Link Assembly Damper and Spring
Solenoid with the mounting position in the Cover Assembly Solenoid, and secure
them with a screw.
Push the Bracket Assembly Damper into the Cover Assembly Solenoid with your
fingers.
Secure the Cover Assembly Solenoid together with the Solenoid Assembly-Gate In
to the H-Tra with two screws.
Insert the Roller into the shaft of the Bracket Assembly so that the convex of the
Roller face is toward the frame.
Clamp the harness of the Solenoid Assembly at five places on the Bracket
Assembly.
Plug the connector (P/J 256M) of the Solenoid Assembly.
Mount the Rear Cover.
4025-Finisher