Guide Assembly-Dust Removal
Removal
1.
Remove the Cover-Jogging.
2.
Remove the Cover-Top, Front and Cover-Top, Rear.
3.
Remove the Cover-Rear.
4.
Remove the Kit Roll Pinch.
5.
Remove the Sensor, Path.
6.
Remove the Puncher.
7.
Lift up the Guide Assembly-Dust a little, pull it off the notch of the Finisher frame, and
tilt the Guide Assembly-Dust to remove them upward.
Replacement
1.
Tilt the Guide Assembly-Dust and insert it into the Finisher from the rear, and align
two bosses of the Guide Assembly-Dust with the notch of the Finisher to mount
them.
2.
Mount the Puncher.
3.
Mount the Sensor, Path and mount the Kit Roll Pinch.
4.
Mount the Cover-Rear.
5.
Mount the Cover-Top, Front and Cover-Top, Rear.
6.
Mount the Cover-Jogging.
4025-Finisher
Removal and Replacement Procedures
4-59