Finisher Diverter Gate Solenoid Removal - Lexmark X850e Service Manual
Booklet finisher
Hide thumbs
Also See for X850e:
- Service manual (843 pages) ,
- User manual (162 pages) ,
- Reference manual (120 pages)
Table of Contents
Advertisement
Finisher diverter gate solenoid removal
1. Open the finisher front door assembly.
2. Remove the rear upper cover. See
3. Disconnect the connector from the finisher diverter gate solenoid (A).
4. Release the harness from the clamp.
5. Remove the two screws securing the bracket (B) to the finisher.
Note: The bracket should not be removed from the finisher, it should be gently moved to provide better
access to the finisher diverter gate solenoid mounting screws.
6. Remove the two screws securing the finisher diverter gate solenoid (A) to the finisher.
7. Remove the finisher diverter gate solenoid (A).
Note: The link (C) may remain inserted into the finisher.
Connector
8. Remove the link.
Note: When the link is removed, the finisher diverter gate may become detached. See
gate removal" on page
"Rear upper cover removal" on page
B
Clamp
)
C
4-90.
Clamp
A
7500-XXX
4-24.
C
"Finisher diverter
4-101
Repair information
Advertisement
Table of Contents
