Creating Startup Files In Solaris; Installing Device Manager - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Installing the Management Software
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Creating Startup Files in Solaris

The Postgre SQL and Fabric Manager does not automatically start-up in Solaris after the installation.
The init files should be created in /etc/init.d, and the following commands should be included in the files.
To start Postgre SQL and FM:
•
•
To stop Postgre SQL and FM:
•
•

Installing Device Manager

To install Device Manager on your workstation, follow these steps:
Enter the IP address of the switch in the Address field of your browser.
Step 1
You see the Installation window for Device Manager shown in
Figure 2-12
Click the Cisco Device Manager link.
Step 2
You see the welcome to the management software setup wizard message in the Cisco Device Manager
Installer window shown in
Cisco MDS 9000 Family Fabric Manager Configuration Guide
2-32
$INSTALL/db/bin/DB start
$INSTALL/bin/FMServer.sh start
$INSTALL/db/bin/DB stop
$INSTALL/bin/FMServer.sh stop
Device Manager Installation Window
Figure
Chapter 2 Installation of Cisco MDS SAN-OS and Fabric Manager
2-13.
Figure 2-12.
OL-8007-10, Cisco MDS SAN-OS Release 3.x