HP Cisco MDS 9216 - Fabric Switch Configuration Manual page 99

Chapter 2 Installation of Cisco MDS SAN-OS and Fabric Manager
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Enter yes (yes is the default) to configure the default network (recommended).
d.
Configure the default network: (yes/no) [y]: yes
Enter the default network IP address.
Note
Default network IP address [dest_prefix]: dest_prefix
Enter yes (yes is the default) to configure the DNS IP address.
e.
Configure the DNS IP address? (yes/no) [y]: yes
Enter the DNS IP address.
DNS IP address: name_server
Enter yes (default is no) to configure the default domain name.
f.
Configure the default domain name? (yes/no) [n]: yes
Enter the default domain name.
Default domain name: domain_name
Step 12 Enter yes (yes is the default) to enable Telnet service.
Enable the telnet service? (yes/no) [y]: yes
Step 13 Enter yes (no is the default) to enable the SSH service.
Enabled SSH service? (yes/no) [n]: yes
Step 14 Enter the SSH key type (see the
would like to generate.
Type the SSH key you would like to generate (dsa/rsa/rsa1)? dsa
Step 15 Enter the number of key bits within the specified range.
Enter the number of key bits? (768 to 2048): 768
Step 16 Enter yes (no is the default) to configure the NTP server.
Configure NTP server? (yes/no) [n]: yes
Enter the NTP server IP address.
a.
NTP server IP address: ntp_server_IP_address
Enter noshut (shut is the default) to configure the default switch port interface to the shut state.
Step 17
Configure default switchport interface state (shut/noshut) [shut]: noshut
Enter on (on is the default) to configure the switch port trunk mode.
Step 18
Configure default switchport trunk mode (on/off/auto) [on]: on
Enter on (off is the default) to configure the PortChannel auto-create state.
Step 19
Configure default port-channel auto-create state (on/off) [off]: on
Enter permit (deny is the default) to deny a default zone policy configuration.
Step 20
Configure default zone policy (permit/deny) [deny]: permit
OL-8007-10, Cisco MDS SAN-OS Release 3.x
The default network IP address is the destination prefix provided in
"Generating the SSH Server Key Pair" section on page
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Initial Setup Routine
Step 11c .
39-16) that you
2-7