Dot1X-4 - Cisco AP775A - Nexus Converged Network Switch 5010 Reference

DOT1X Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
portchannel, dot1x host mode will be multi-host and changing it to single-host
mode won't be supported
Error Message
stopped: [chars] [chars]
Error Message
mode will be multi-host and changing it to single-host mode won't be supported
DOT1X-5
Error Message
Error Message
Error Message
trying to authenticate.
Cisco NX-OS System Messages Reference
2-130
DOT1X-4-MULTIHOST_ON_PCM: Interface [chars] is a member of
Current Port is a member of port channel, so dot1x host mode has to be in multi-host
Explanation
mode.
To change host mode, ensure that port is not a member of port channel.
Recommended Action
DOT1X-4-STOPPED: Event [chars] ignored because the state machine is
An attempt was made to post an event to a state machine that has already been stopped.
Explanation
An internal error has occurred with the state machine. The traceback should
Recommended Action
indicate the guilty party.
DOT1X-4-TO_MULTIHOST: Interface [chars] is in trunk mode, dot1x host
Current Port is in trunk mode, so dot1x host mode has to be in multi-host mode.
Explanation
To change host mode, ensure that port is not in trunk mode.
Recommended Action
DOT1X-5-DOT1X_DISABLED: dot1x Disabled
Dot1x service has been disabled.
Explanation
No action is required.
Recommended Action
DOT1X-5-DOT1X_ENABLED: dot1x Enabled
Dot1x service has been enabled.
Explanation
No action is required.
Recommended Action
DOT1X-5-INVALID_MAC: broadcast or multicast mac address) [chars] is
Authentication using 802.1x is not allowed for zero, broadcast, and multicast source
Explanation
MAC addresses.
Connect a Dot1x supported Host to the Dot1x enabled port.
Recommended Action
Chapter 2 System Messages and Recovery Procedures
OL-15994-03