Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 93

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
Explanation
Parameters: Data Type ...
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
%s/%d
Explanation
Parameters: Address-family, Prefix/masklength ...
Recommended Action
Error Message
Explanation
Parameters: Path Type, Error ...
Recommended Action
configuration to decrease memory requirements. Clear any BGP peers that may have been shut down
automatically. If BGP has available memory, restart BGP.
Error Message
%s, should not be stale
Explanation
Parameters: Address-family, Path State, Operation, Prefix/masklength, Peer address ...
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
Explanation
Parameters: Peer address, Operation ...
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
Explanation
Parameters: Data Type, Prefix/masklength ...
Recommended Action
Support web site http://www.cisco.com/tac.
OL-15994-03
BGP-3-NOMEMORY Format: Could not allocate %s
The system may be low on memory.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
BGP-3-NONBESTPATH Format: [%s] Non bestpath in attr. path chain for
An internal software error occurred.
Use the 'restart' command to restart the feature and clear this problem.
BGP-3-PATH_DEL Format: Failed to destroy path (%s), error %d
The BGP process may have run out of memory.
If BGP ran out of memory, add memory to the router or change the network
BGP-3-PATH_STALE Format: [%s] %s path being %s, for %s/%d from peer
An internal software error occurred.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
BGP-3-PEER Format: Peer %s, failed %s
An internal software error occurred.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
BGP-3-PFX_NOMEM Format: Could not allocate %s for %s/%d
The system may be low on memory.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Cisco NX-OS System Messages Reference
BGP Messages
2-55