Callhome Messages - Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
BOOTVAR-6
Error Message
Error Message
Error Message

CALLHOME Messages

This section contains the CALLHOME messages.
CALLHOME-2
Error Message
Error Message
OL-15994-03
BOOTVAR-6-ALREADY_IN_SYNC: Image already in sync
This message indicates that you do not need to update the image on the standby
Explanation
supervisor module.
No action is required.
Recommended Action
BOOTVAR-6-CONFIG_UPDATED: Boot configuration updated
The boot-loader configuration files have been successfully updated.
Explanation
No action is required.
Recommended Action
BOOTVAR-6-STARTING: Boot configuration initialized
The service has successfully started.
Explanation
No action is required.
Recommended Action
CALLHOME-2-EVENT: [chars]
A Call Home event [chars] occurred.
Explanation
Recommended Action If you have configured your e-mail address to receive Call Home notifications,
check your e-mail for more details about this Call Home event. If Call Home was not enabled,
execute commands relevant to the callhome event to get more information about the error.
CALLHOME-2-PROGRAM_EXIT: callhome process ending: [chars]
A Call Home process is exiting with the reason [chars].
Explanation
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Recommended Action
Support web site http://www.cisco.com/tac.
CALLHOME Messages
Cisco NX-OS System Messages Reference
2-71