Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 728

SYSMGR Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
unexpectedly high at [dec]%.
Explanation
Recommended Action
message continues to persist, please contact TAC.
Error Message
Explanation
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
[chars] (error-id [hex]).
Explanation
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
([dec]).
Explanation
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
since its coming up as active when local sup is still active.
Explanation
will cause the remote sup to reset itself.
Recommended Action
Error Message
standby on the redundancy channel not working for last [dec] minutes.
Explanation
supervisor. This can result in problems during switchover and switchover may even fail.
Recommended Action
Support web site http://www.cisco.com/tac.
Cisco NX-OS System Messages Reference
2-690
SYSMGR-2-PSS2_VOLATILE_DB_FULL: Volatile database usage in kernel is
The system volatile database in kernel space is almost full.
Please run the command 'system system internal pss kernel memstats'. If this
SYSMGR-2-PSS2FILE_CONVERT_FAILED: Conversion of file [chars] failed.
Conversion of internal data format failed.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
SYSMGR-2-REDSTATE_GETFAILED: Failed to request redundancy state:
The local supervisor is unable to get the redundancy state.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
SYSMGR-2-REDSTATE_SETFAILED: Failed to set redundancy state: ret_val
The local supervisor is unable to get the redundancy state.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
SYSMGR-2-REDUNDANCY_CHANNEL_FAILURE: Remote sup will be rebooted
Remote sup is becoming active although local sup is still active. As a result, local sup
If the problem persists, please contact customer support.
SYSMGR-2-REDUNDANCY_HEARTBEAT_FAILURE: Heartbeat between active and
This supervisor is not receiving heartbeat on the redundancy channel from the other
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Chapter 2 System Messages and Recovery Procedures
OL-15994-03