Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 524

PLATFORM Messages
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
timeout - [chars])
Explanation
Recommended Action
'show hardware internal aipc event-history msgs'. The event logged will be E_AIPC_TXTIMEOUT.
Error Message
obtained. Please contact your Cisco account team or partner to purchase Licenses.
To activate your purchased licenses, click on www.cisco.com/go/license.
Explanation
Recommended Action
Support web site http://www.cisco.com/tac to obtain a license.
Error Message
Line Interface
Explanation
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
missing plugin
Explanation
Recommended Action
Error Message
ps-redundancy might be affected
Explanation
Recommended Action
Cisco NX-OS System Messages Reference
2-486
PLATFORM-2-PFM_VEM_REMOVE_NO_HB: Removing VEM [dec] (heartbeats lost)
The system has detected that a VEM has been removed due to lost heartbeats.
No action is required.
PLATFORM-2-PFM_VEM_REMOVE_RESET: Removing VEM [dec] (VEM reset)
The system has detected that a VEM has been removed because due to a reset request.
No action is required.
PLATFORM-2-PFM_VEM_REMOVE_TX_ERR: Removing VEM [dec] (transmit
The system has detected that a VEM has been removed due to a transmit timeout.
You can collect information about the transmit timeout using the command
PLATFORM-2-PFM_VEM_UNLICENSED: License for VEM [dec] could not be
A VEM license could not be obtained.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
PLATFORM-2-PFM_XBAR_RESET: Manual restart of Xbar [dec] from Command
User initiated a xbar reload from the CLI.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
PLATFORM-2-PLUGIN_ABSENT: Module in slot[dec] (sw_card_id=[dec]) has
Plugin not loaded, The LC cannot be powered up.
Load the associated plugin.
PLATFORM-2-PS_ABSENT: Power supply [dec] is absent/shutdown,
Power Supply is absent.
No action is required.
Chapter 2 System Messages and Recovery Procedures
OL-15994-03