Svc-6 - Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
Flash Copy Copied [chars]
Explanation
The target disk now contains a complete copy and is no longer dependent on the source.
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
) Flash Copy Prepared [chars]
Explanation
now possible to Start or Stop the mapping/group.
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
SS_EID_IC_EV_CLUSTER_RECOVERY_COMPLETE ) Cluster recovery completed [chars]
Explanation
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
node in the IO group is not available [chars]
Explanation
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
SS_EID_IC_EV_SECURE_DELETE_COMPLETE ) Virtual Disk format completed [chars]
Explanation
Recommended Action
Support web site http://www.cisco.com/tac.
Error Message
software started [chars]
Explanation
Recommended Action
Support web site http://www.cisco.com/tac.
OL-15994-03
SVC-6-NODE_INFO_MSG: (SVC [dec]/[dec] SS_EID_FC_ER_COPY_COMPLETED )
The Flash Copy mapping or consistency group has entered the IDLE_COPIED state.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
SVC-6-NODE_INFO_MSG: (SVC [dec]/[dec] SS_EID_FC_ER_PREPARE_COMPLETED
The Flash Copy mapping or consistency group has entered the PREPARED state. It is
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
SVC-6-NODE_INFO_MSG: (SVC [dec]/[dec]
Cluster recovery has completed successfully.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
SVC-6-NODE_INFO_MSG: (SVC [dec]/[dec] SS_EID_IC_EV_IOGRP_ONE_OK ) One
Following node remove by the user, there is only one node left in the IO group.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
SVC-6-NODE_INFO_MSG: (SVC [dec]/[dec]
The formatting (writing all zeros) to new extents of the Virtual Disk has completed.
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
SVC-6-NODE_INFO_MSG: (SVC [dec]/[dec] SS_EID_PL_ER_COLDSTART ) Node
The node software has been started (cold start).
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Cisco NX-OS System Messages Reference
SVC Messages
2-653