Pim-5 - Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
PIM-6
Error Message
Error Message
use shared tree config is %d
Error Message
supported
Error Message
Error Message
OL-15994-03
PIM-5-NBR_CHANGE Format: Neighbor %s %s on interface %s
PIM neighbor went up/down due to Hello-message seen/lost.
Explanation
Parameters: Neighbor IP address, Neighbor state, Interface ...
Recommended Action No action is required.
PIM-6-IF_DEPEND Format: Removed interface (%s) has %s dependency
There is residual configuration on the deleted interface.
Explanation
Parameters: Interface name, Dependent Config Command ...
No action is required.
Recommended Action
PIM-6-MAX_GRANGES Format: Max Granges allowed to be configured for
Exceeded the group range limit.
Explanation
No action is required.
Recommended Action
PIM-6-MAX_RPS Format: Cannot store bidir-RP %s, a maximum of %d are
Due to hardware limitations, there is a maximum number of Bidir-PIM RPs that can be
Explanation
stored.
Recommended Action No action is required.
PIM-6-MQFLUSHED Format: Flushing %lu messages from %s mq
Flushing old residual messages fom the message-queue.
Explanation
Recommended Action No action is required.
PIM-6-MQLOOP_UNKNOWN_MSG Format: Received unknown message %d/%d
Explanation PIM process received unknown Interprocess message, dropped.
No action is required.
Recommended Action
Cisco NX-OS System Messages Reference
PIM Messages
2-455