Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 325

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
[hex] for VSAN [dec]
IPS-4
Error Message
Acceleration configuration with peer
Error Message
update had an error ([chars]) on interface [chars] causing a flap of the interface
Error Message
[chars] for license failure; configuration accepted but bind failed
IPS-5
Error Message
[chars]
OL-15994-03
IPS-3-ISLB_ZONE_NO_ACTIVE_ZONESET: iSLB zonset activation returned
Explanation ISLB zone set activation failed. No active zone set.
Activate a zone set in the specified VSAN and retry.
Recommended Action
IPS-4-FCIP_FTA_CFG_MISMATCH: [chars]: Mismatch in FCIP Ficon Tape
Explanation The FCIP Ficon Tape Acceleration configuration does not match with peer's
configuration.
Recommended Action Fix the FCIP Ficon Tape Acceleration configuration to be consistent with the
peer.
IPS-4-FCIP_FTA_VSAN_UPDATE_WARNING: FCIP FICON tape acceleration VSAN
The FCIP FICON tape acceleration VSAN configuration experienced an error when
Explanation
disabling and enabling the VSAN over the FCIP tunnel. The FCIP tunnel was disabled and reenabled
as a result of this error to ensure data integrity.
No action is required.
Recommended Action
IPS-4-FCIP_LICENSE_BIND_FAILED: Bind failed for [chars] due to
The FCIP configuration was accepted, but the FCIP interface did not bind to a physical
Explanation
interface because the appropriate license was not available. If a license becomes available in the
future, this FCIP interface will bind to a physical interface automatically.
Check the license state with show license usage and acquire the necessary
Recommended Action
FCIP license.
IPS-5-FCIP_BIND_FAILED: Bind failed for [chars] due to [chars] for
FCIP/ISCSI Interface bind to Ethernet port failed.
Explanation
No action is required.
Recommended Action
Cisco NX-OS System Messages Reference
IPS Messages
2-287