Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 551

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
disabled - Possible PortChannel misconfiguration)
Explanation
Recommended Action
port channel or are not both part of port channel.
Error Message
down(Invalid fabric binding exchange)
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
is down (fcdomain applied a locally disruptive reconfiguration)
Explanation
Recommended Action
Error Message
failure)
Explanation
Recommended Action
module' to connect to the module.
Error Message
(Isolation due to port loopback to same switch)
Explanation
Recommended Action
another switch.
Error Message
removed)
Explanation
Recommended Action
OL-15994-03
PORT-5-IF_DOWN_INVALID_CONFIG: Interface [chars] is down(Error
The local and peer port have a port channel membership misconfiguration.
Ensure that both the local and peer ports are either both members of the same
PORT-5-IF_DOWN_INVALID_FABRIC_BINDING: Interface [chars] is
Fabric binding failed.
Check fabric binding database.
PORT-5-IF_DOWN_LINK_FAILURE: Interface [chars] is down (Link failure)
The physical link has gone down.
Ensure that the cable is connected and the remote end is not shut down.
PORT-5-IF_DOWN_LOCALLY_DISRUPTIVE_RECONFIGURATION: Interface [chars]
Fcdomain applied a locally disruptive reconfiguration (local domain became invalid))).
No action is required.
PORT-5-IF_DOWN_LOOPBACK_DIAG_FAILURE: Interface [chars] is down (Diag
The diagnostics failed on the interface.
Collect more information about the failed interface using the command 'attach
PORT-5-IF_DOWN_LOOPBACK_ISOLATION: Interface [chars] is down
The interface is looped back to another interface on the same switch.
Check the connectivity of this interface and ensure that it is connected to
PORT-5-IF_DOWN_MODULE_REMOVED: Interface [chars] is down (module
The system has detected that an interface is down because the module was removed.
No action is required.
Cisco NX-OS System Messages Reference
PORT Messages
2-513