Cisco AP775A - Nexus Converged Network Switch 5010 Reference page 517

Chapter 2 System Messages and Recovery Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
non-availability of xbar modules
Explanation
Recommended Action
'show module internal all module [decimal digit]' to collect more information if you suspect module
has been powered down due to errors.At leastone xbar module has to be for modules to function.
Error Message
Module-Type [chars] Model [chars]
Explanation
Recommended Action
Error Message
insufficient power (Serial number [chars])
Explanation
Recommended Action
env power'. Refer to power supply document on how to increase power supply capacity.
Error Message
[chars])
Explanation
Recommended Action
'show module internal all module [decimal digit]' to collect more information if you suspect module
has been powered down due to errors.
Error Message
[chars])
Explanation
Recommended Action
information.
Error Message
[dec] will not be powered up (Serial number [chars])
Explanation
Recommended Action
internal all module [decimal digit]' 'show sprom xbar [dec] [dec]' to read module IDPROM contents
to collect more information.
OL-15994-03
PLATFORM-2-MOD_ALL_PWRDN_NOXBAR: All modules powered down due to
All modules in switch are powered down because all xbar modules are offline.
Enter a 'show module', 'show platform internal all module [decimal digit]' and
PLATFORM-2-MOD_DETECT: Module [dec] detected (Serial number [chars])
A new module in slot [decimal digit] is detected.
No action is required.
PLATFORM-2-MOD_PWRDENY: Module [dec] can not be powered up due to
Available power in power supplies is not sufficient to power up the module.
You can verify available power and current usage using the command 'show
PLATFORM-2-MOD_PWRDN: Module [dec] powered down (Serial number
The module in slot [decimal digit] is powered down.
Enter a 'show module', 'show platform internal all module [decimal digit]' and
PLATFORM-2-MOD_PWRFAIL: Module [dec] failed to power up (Serial number
The module in slot [decimal digit] failed to power up.
Enter a 'show platform internal all module [decimal digit]' and to collect more
PLATFORM-2-MOD_PWRFAIL_EJECTORS_OPEN: Both ejectors open, Module
The module cannot be powered up because both ejectors are open.
Enter a 'show platform internal all module [decimal digit]' and 'show module
PLATFORM Messages
Cisco NX-OS System Messages Reference
2-479